Installation Guide

Installation Instruction

Item No: 7507-1H

WARNING: To avoid risk of electrical shock, be sure to shut off power while installing or

servicing this fixture.

NOTE: We advise calling a qualified electrician when making the wire connections to the junction box.

WARNING:

1. Shut off the power to the area where you will be working.

2. Use 60 Watts maximum type B bulb.

3. Do not use polish or clearer on your fixture, just wipe with soft cloth as needed.

STEP 1 – Unpack

1. Carefully unpack your new fixture and lay out all the parts on a clean surface.

STEP 2 – Assembly

1. Install E26 bulb into the socket (BULBS NOT INCLUDED).

2. Install the hook (B) into the hook (A) on the frame as shown in drawing.

There are 2 ways to install this chandelier:

 Portable Wire – STEP 3

 Hardwire – STEP 4

NOTE: FOR HARDWIRE INSTALLATION WE ADVISE CALLING A QUALIFIED

ELECTRICIAN WHEN MAKING THE WIRE CONNECTIONS TO THE JUNCTION BOX.

3. PORTABLE WIRE INSTALLATION

NOTE: Cute off the fixture copper ground wire

CAUTION: DO NOT install on a radiant heating ceiling

CAUTION: The hooks are to engage the chain only and not the electrical wire.

FOR PLASTER OR PLASTER BOARD CEILINGS

1. Drill a hole in the ceiling to the same diameter as the closed flaps of the

included toggle bolt assembly (A).

2. Insert flaps and bolt into the ceiling with the toggle bolt protruding through

the ceiling, lock the assembly by threading on the hook as shown.

3. Drape your chain to the second hook or let it hang straight.

FOR WOOD OR ACOUSTIC BOARD CEILINGS - MINIMUM THICKNESS IS 1-1/2 INCH

1. Select a place on the ceiling where a wood beam exists.

2. Thread the steel screw (B) into hook (C).

3. Screw the assembly into the wood beam.

4. Drape your chain to second hook or let it hang straight.

PAGE 1
Installation Instruction Item No: 7507-1H WARNING: To avoid risk of electrical shock, be sure to shut off power while installing or servicing this fixture. NOTE: We advise calling a qualified electrician when making the wire connections to the junction box. WARNING: 1. 2. 3. Shut off the power to the area where you will be working. Use 60 Watts maximum type B bulb. Do not use polish or clearer on your fixture, just wipe with soft cloth as needed. STEP 1 – Unpack 1.
PAGE 2
HOOK THE CHANDELIER ASSEMBLY TO THE CHAIN 1. Open the lock link (K1) provided, connect to the fixture loop (J) and chain link and close the lock link (K1). 2. One chain and wire are arranged, plug the wire plug into household electrical outlet. IMPORTANT SAFETY INFORMATION: This portable fixture has a polarized plug (one blade is wider than the other.) As a safety feature, this plug will fit a polarized outlet only one way. If the plug does not fit fully in the outlet reverse the plug.