User's Manual

Wireless Tree Network and Roaming
Quick Setup Example
Antennas
A B
1 – root
Omni not used
2 – branch
Directional
(point to 1)
Omni
3 – branch
Directional
(point to 1)
Omni
4 – branch
Directional
(point to 3)
Omni
5 – branch
Directional
(point to 3)
Omni
6 - leaf
Omni not used
Minimum Configuration
1 2 3 4 5 6
>load factory >load factory >load factory >load factory >load factory >load factory
>node type=root-1 >node type=branch >node type=branch >node type=branch >node type=branch >node type=leaf
>rf1 tr=12 rec=12
(1)
>rf1 rec=12
(1)
>rf1 rec=12
(1)
>rf1 rec=25 >rf1 rec=25 >rf1 rec=6,12,18,25,32
>rf2 tr=6 rec=6 >rf2 tr=25 rec=25
(1)
>rf2 tr=18 rec=18 >rf2 tr=32 rec=32
>save >save >save >save >save >save
Note 1: Channel 12 and 25 are the defaults for rf1 and rf2 configurations. These commands are not necessary if you plan to use those defaults.
At any node use command “>show tree” to view the complete network and key statistics for each link.
At the mobile use the command “>monitor-roam” to see the signal strengths and verify the roaming operation as the signal strengths vary.
1
23
45
6
(mobile)
Ch 12
Ch 25
Ch 32Ch 18
Ch 6