User's Manual

pulsAR radio Operator’s Manual
3-15
>console-speed-bps 57600
4. Change the baud rate of the PC to match the radio. Remember that with HyperTerminal, you
must disconnect the session and re-connect before the changes will take effect. Verify the PC
communicates with the radio again.
5. If the radio configuration has been password protected, you must first unlock the protection with
the command:
>unlock enable-configuration=password
(when the configuration is unlocked, the radio prompt ends with the characters ‘#>. In locked
mode the prompt does not include the ‘#’ character).
6. Issue the command:
>directory
to view a list of files stored in Flash PROM as well as the available free space. Verify that there
is enough free space in flash PROM for the new file. The space required will be the size of the
pmp0x_xx.dwn file divided by 2.5. If there is not enough space in Flash PROM delete one of the
program files to make up space (use command >delete filename).
7. Start the download process by typing:
>download-file destination=pmp0x_xx method=inline
where 0x_xx file is new version of software being installed.
8. The radio will return with the following:
“Send the file ... if incomplete, end with a line with just a period”
When you get this prompt, go to “Transfer-Send Text file…” in HyperTerminal and select the file
to be installed. The file must have a “.dwn” extension.
9. After the file is successfully installed issue the command:
>directory
to insure that the file has been loaded into memory.
10. Issue the command:
>set-default-program pmp0x_xx
where 0x_xx file is new version of software being installed.
11. Issue the command:
>reboot
to restart the radio with the new software. Remember to change the PC HyperTerminal settings
back to 9600 baud and disconnect/re-connect the session.
12. Issue the command:
>version
to insure the radio is running the latest version.