Installation Guide

Square Wrap
Square Wrap
Square Wrap
-
-
-
Around Aluminum Column
Around Aluminum Column
Around Aluminum Column
INSTALLATION INSTRUCTIONS
S
QUARE
W
RAP
-A
ROUND
A
LUMINUM
C
OLUMN
AFCO INDUSTRIES, INC., P.O. BOX 5085, ALEXANDRIA, LA 71307
AFCO Form ALO6-S Rev. 7/2013
For more information, contact Customer Service at 1-800-599-9912 or visit our website at www.afco-ind.com.
1. Measure the height of the opening where the column will be placed. Cut each col-
umn stave (piece)
1/4” longer than the opening. A circular saw with a metal cutting
blade is recommended for cutting the staves.
2. To assemble the column, snap the interlocks of two staves together beginning at
one end and continuing along the length of the column. Continue to add staves in
this manner, until all staves are together. Tap lightly with a rubber mallet if necessary
to ensure the joints are fully engaged. For wrap-around-post installation follow above
instructions but add final stave with the partially assembled column in an upright posi-
tion around the interior post.
3. To secure the column, attach the column to the overhead beam or header with the
appropriate fasteners and screws. Repeat this at the bottom of the column.
Note: High performance tie down brackets are available at an additional charge.
4. To assemble and install the capital and base, place the two pieces of the base around
the bottom of the column, flush with the floor and insert the provided screws to secure
in place. Repeat this process with the capital at the top of the column. Be sure the cap-
ital is flush with both the header and the base. If needed, caulk between seams for a
finished look.
Notes:
a. For best load-bearing performance, utilize AFCO load-bearing plates to spread the load over the entire perimeter of
the column. Load-bearing capacity is dependent on distributing the load evenly over the surfaces of the shaft.
b. All column staves should be cut square and to the same length.
c. Installation should be on a smooth level surface.
d. 2nd story balconies should not be attached directly to the side of any column.
e. Columns should be installed according to standard construction practices and in compliance with applicable local,
state, and federal regulations.
C OLUMN S IZE S TAVES P ER C OLUMN
M
AXIMUM S IZE OF E XISTING
R
OUND P OST
M
AXIMUM S IZE OF E XISTING
S
QUARE P OST
4 2 3” 3”
6 4 4
7/8” 4 1/2”
SIZE CHART
8 4 6
7/8” 6 1/2”
10 4 8
1/2” 8 1/2”
12 8 10” 10”