Owners manual

9956-1 2010+ FJ Cruiser Front 04/16 (Rev C)
8. Screw the tie rod end nut upside down (the safety pin slots facing the ground) back on to
the tie rod end bolt until the top of the bolt is level with the top of the nut. Make sure the
threads of the bolt are not higher than the nut. Using a hammer hit the tie rod end bolt out
of its place. Once the tie rod end bolt breaks loose remove the nut and the tie rod end.
9. Using a 17mm wrench or socket remove the sway bar link lower nuts and disconnect the
sway bar links from their lower ends by pulling them out.
Note: Steps 5 to 8 must be done for both left and right sides before the removal of the sway
bar.
10. Using a 12mm wrench or socket remove the four bolts under the skid plate and remove
the skid plate.