Owners manual

ManualsBrandsAFE Filters ManualsAutomotive301-5600-06 Sway-A-Way Front Coilover Kit Fits 09-13 F-150

9992 –09-13 F150 FONT Coilovers (RevB).docx

252 Granite St, Corona, CA 92879

Phone # 888-901-7693

afepower.com/swayaway

2009-2013 Ford F150 2wd/4wd Coilover Kit Installation

Parts List:

-2 Sway-A-Way shocks.

-2 Reservoir Mount Brackets and hose clamps.

-1 Spanner Wrench

Tool List

-8mm, 10mm, 21mm, and 30mm sockets

-16mm and 3/4in deep socket

-19mm open end wrench

-Crescent wrench

-Ball joint remover

-Jack and jack stands

-Impact wrench (optional)

-Safety glasses

Summary of content (4 pages)

PAGE 1
252 Granite St, Corona, CA 92879 Phone # 888-901-7693 afepower.com/swayaway 2009-2013 Ford F150 2wd/4wd Coilover Kit Installation Parts List: -2 Sway-A-Way shocks. -2 Reservoir Mount Brackets and hose clamps. -1 Spanner Wrench Tool List -8mm, 10mm, 21mm, and 30mm sockets -16mm and 3/4in deep socket -19mm open end wrench -Crescent wrench -Ball joint remover -Jack and jack stands -Impact wrench (optional) -Safety glasses 9992 –09-13 F150 FONT Coilovers (RevB).
PAGE 2
Removal and Installation Procedure for F150 Front (Shocks are already charged with 200 PSI of Nitrogen) 1. Park the vehicle on a level concrete surface where it is safe to work on your vehicle. 2. Lock and center the steering wheel. 3. Place blocks in front and behind the rear tires so as to keep the vehicle from moving forwards or backwards. 4. One side at a time, place the jack under the frame and raise the truck until the jack stand can be placed under the lower arm mount. 5.
PAGE 3
12. Place and raise the jack under the lower arm to take the weight off the shock. 13. Use the 16mm deep socket to remove the 3 nuts holding the top of the shock to the mount 14. Remove the lower shock mount bolt using the 30mm socket and impact gun on the nut and a crescent wrench on the bolt head. 15. Use the ball joint remover to remove the upper spindle ball joint and slightly lower the jack to allow the arm to droop. 16.
PAGE 4
19. Place the reservoir in the bracket and tighten the hose clamps. Hose clamps should be placed through the openings in the bracket. 20. Double check that every bolt that was removed has been retightened. Reinstall wheels and tighten lug nuts to factory spec. 21. If you are happy with the achieved lift you are done. If you would like to change the height of the vehicle, you can use the supplied spanner wrench to raise or lower the height.