Installation Manual

Refer to Figure G for steps 16-17
Step 16: Re-connect the Mass Air Flow Sensor and Humidity Sensor. Re-connect the temperature
sensor by routing harness across the intake tube.
Step 17: Check all the components are tight and secure. Your installation is now complete. (Use
furnished plug to close additional air inlet if you want to completely seal the air box.
Step 18: Re-connect negative battery terminal.
Step 19: (Optional) To seal up auxiliary opening of air box positioned in front of grill, use supplied plug.
NOTE: Check all bolts, clamps, and connectors after 200 miles. Place enclosed CARB EO sticker on or near
the device on a smooth/clean surface. EO identification label is required to pass the smog test inspection.
Page 10
Figure G
INSTALL