Installation Manual

Label Qty. Description Part Number
A 1 Seal, Trim: 7/16" (26"L) 05-00072
B 1 Housing 05-82302B2
C 1 Plug, Urethane 05-01202
D 1 Clamp, T-bolt (8-5/16") 03-50267
E1 1 PRO 10R (Blue Media) 20-91059
E2 1 PRO DRY S (Grey Media) 21-91059
F 1 Tube 05-74006B1
G 1 Gasket 05-00631
H 1 Block Off Plate 05-01372
I 2 Screw, M4 x 12mm 03-50455
J 4 Screw, Torx: M4 x .7 x 8mm 03-50491
K 2 Clamp, T-Bolt (4-7/16”) 03-50319
L 1 Coupling, Silicone Dbl. Hump 05-01430
M 1 Cap 03-50103
N 1 Grommet 03-50033
Installation will require the following tools:
8mm Nut driver, 10mm Nut driver and Torx (T-20) driver.
• Please read the entire instruction manual before proceeding.
• Ensure all components listed are present.
• If you are missing any of the components, call customer support at 951-493-7100
or e-mail at [e-mail].
• Ensure you have all necessary tools before proceeding.
• Do not attempt to work on your vehicle when the engine is hot.
• Disconnect the negative battery terminal before proceeding.
• Retain factory parts for future use.
Page 2