Installation Manual

Page 8
Refer to Figure E for steps 9-13
Step 9: Remove Mass Air Flow Sensor and Humidity Sensor from the factory air box using a Torx (T-20)
driver.
Step 10: Install Mass Air Flow Sensor and Humidity Sensor (use factory gasket for Humidity Sensor) into
the Momentum HD intake tube using supplied M4 screws. If vehicle does not have the
humidity sensor, use the supplied gasket, M4x 12mm flathead screws, and block off plate
to seal opening.
Step 11: Remove the filter minder and grommet from factory air box.
Step 12: Install factory grommet into Momentum HD intake tube, then firmly press filter minder into it. If
your vehicle is not equipped with a filter minder, just plug off the hole with the provided grommet and cap.
Step 13: Install furnished silicone hump coupler and T-bolt clamps on the aFe tube. Do not tighten
clamps at this time.
Figure E
INSTALL