User`s guide

/
BOLT(C)
16mm
Qty:6
WASHER(D)
25mm
Qty:6
WAVYWASHER(J) AXEL
29mm ( @ Qty:2
Qty:2
TOPHANDRAIL
CRANK
BOLT(C)
WASHER(B)
SWINGCAP
BOLT(C)
WASHER(B)
X
WAVYWASHER(J)\
_\
\
/
AXLE
/ BOLT(C)
SWINGCAP
WASHER(B)
RIGHTSWINGARM
ARM
PACKAGINGPLASTICJ
A Laywastepackagingplastic overthe BASERAIL.This will preventthe PEDALARMassemblyfrom scratching
the ascenttrainers paint.
B OpenHARDWAREBAG8.
C Attach right SWINGARMto TOPHANDRAILusing 2 SWINGCAPS,2 BOLTS(C), 2 AXLESand 2WASHERS(D).
D Attach the right PEDALARMto the right CRANKusing 1 WAVYWASHER(J),1WASHER(D) and 1 BOLT(C).
E Attach the CRANKCAPto the CRANK.
F Repeaton oppositeside.
BOLT(N)
45mm
Qty:2
WASHER(L) RODBEARING_ SPACER_ NUT(G)
18ram (0) ) SHAFT Qty:4 8ram
Qty:2 Qty:2 Qty:2
LOWER
BOLT(N)
/
/
/
LiNKARM
A OpenHARDWAREBAG9.
B Slide 1RODBEARINGSHAFTintothe joint endof right LINKARM.
C Fit 1 SPACERon eachside of eachRODBEARINGSHAFTafter the RODBEARINGSHAFTSare inLINKARM.
D Attach right LINKARMto the right LOWERHANDLEBARusing 1BOLT(N), 1WASHER(L) and 1 NUT(G).
E Repeaton oppositeside.
18.0 AXT Rev.2.4.indd 14-15 9/24/08 1:42:10 PM