Owner`s manual

30 | 2008 AFG Service Seminar [rev 1.3]
Section Two | Resetting The Incline Motor
>> Resetting the Incline Motor after replacing the Motor Control Board
Tools Required:
• Philips Screwdriver
• 17mm Socket
• 17mm Combination Wrench
Procedure:
1 | Turn off power to the treadmill and unplug power cord from wall outlet.
2 | Replace the Motor Control Board.
3 | Fold treadmill into locked position.
4 | Undo bolt that attaches the elevation tube to the bottom of the machine (F1)
F1
F2
5 | Power up the machine and let the incline spin freely in the tube until it reaches its “zero” position,
and then turn power off.
6 | Spin shaft manually until it is almost ush with the incline motor casing and only about 1 thread is
visible (F2).
7 | Reinsert bolt and power up the machine.
8 | Test the incline function and calibrate the unit.
17 mm Bolt
17 mm Nut
Proper Zero
Shaft Position