Owner`s manual

72 | 2008 AFG Service Seminar [rev 1.3]
Section Three | Known Issues
Known Issues
>> Treadmills
Issue Solution | Plan of Action
Models | 2.3T, 3.3T, 5.3T (2007)
Making noise when at the 0% incline, makes no
noise when there is no weight on the unit but
as soon as weight is applied it makes a banging
noise. If unit is put inclined the noise stops.
Manually screw the incline motor shaft further into
the motor another thread.
Polar receivers seem to have a too short of a range
so that the customer has to lean into the console
to get a reading.
Try repositioning the receiver and testing. If that
does not work replace with a PST8 polar receiver.
It has a longer wire and can be positioned under
the console plastic.
200 units produced where the shading is incorrect
on the overlays. You can see the UCB and not the
LCD screens.
Replace overlay
Models | 4.2T, 5.2T (2006)
4.2T and 5.2T speed increases gradually when the
pulse grips are held. The speed doesn’t go down
when the customer releases the grips. The
console does beep signifying the change in speed.
Replace UCB with updated software
Models | 3.2T (2006)
Hardware/software compatibility issues, 2nd
generation digital MCB.
Replace UCB with updated software