User`s guide

14
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
Open HARDWARE BAG 7.
Remove NUT, WASHERS, SCREW, HOOK, CLEVIS and BALL STOP from one end of CABLE B.
Route CABLE B through the pulley system in the RADIAL ARM ASSEMBLY as shown in
diagram.
NOTE: Thread cable through SINGLE FLOATING PULLEY between each arm of the RADIAL
ARM ASSEMBLY.
After CABLE B routing is complete replace BALL STOP, CLEVIS, HOOK, SCREW, WASHERS
and NUT on end of cable.
NOTE: Ensure the “O” RINGS are positioned at the ends of CABLE B against the BALL
STOPS.
Hook HANDLES on to cable using the 2 HOOKS.
A
B
C
D
E
ASSEMBLY STEP 7
CABLE B
Qty: 1
HARDWARE BAG 7 CONTENTS :
CABLE B
CABLE B
SINGLE FLOATING
PULLEY BRACKET
RADIAL
ARM ASSEMBLY
BALL STOP
“O” RING
NUT
WASHER
HANDLE
HANDLE
HOOK
CLEVIS
WASHER
SCREW
Open HARDWARE BAG 8.
Remove NUT, WASHERS, SCREW, HOOK, CLEVIS and BALL STOP from one end of CABLE C.
Install CABLE C as shown in diagram. Ensure that the SINGLE FLOATING PULLEY BRACKET
is installed after passing through two upper pulleys.
After CABLE C routing is complete replace BALL STOP, CLEVIS, HOOK, SCREW, WASHERS
and NUT on end of cable.
NOTE: Ensure the “O” RINGS are positioned at the ends of CABLE C against the BALL
STOPS.
Install lat bar using the 2 HOOKS.
A
B
C
D
E
ASSEMBLY STEP 8
CABLE C
Qty: 1
HARDWARE BAG 8 CONTENTS :
CABLE C
UPPER PULLEY
ASSEMBLY
SINGLE FLOATING
PULLEY BRACKET
BALL STOP
“O” RING
NUT
WASHER
LAT BAR
LAT BAR
HOOK
CLEVIS
WASHER
SCREW
2.0AS_Rev.1.5.indd 14-15 9/23/08 10:14:56 AM