User`s guide

BEFORE
YOU BEGIN
14
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
ASSEMBLY STEP 7
SCREW (V)
ELBOW COVERS
BOLT (U)
LOWER LINK ARM
SCREW (T)
PEDAL ARM COVER
A) Open HARDWARE BAG FOR STEP 7.
B) Attach PEDAL ARM COVER into LEFT PEDAL ARM using 1 SCREW (T).
C) Repeat on other side.
D) Attach the INSIDE and OUTSIDE ELBOW COVERS to the right LOWER LINK ARM using 2 BOLTS (U).
E) Tighten the ELBOW COVERS together at the front using 1 SCREW (V).
F) Repeat on other side.
SCREW (T)
15 mm
Qty: 2
BOLT (U)
8 mm
Qty: 4
SCREW (V)
10 mm
Qty: 2
HARDWARE BAG FOR STEP 7 CONTENTS :
4.0 AE SHOWN
ASSEMBLY STEP 8
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Attach the CONSOLE MAST wires to the CONSOLE wires.
B) Carefully tuck the CONSOLE MAST wires into the CONSOLE MAST before attaching the CONSOLE.
DO NOT PINCH WIRES!
C) Attach CONSOLE to the CONSOLE MAST using the 4 PRE-ATTACHED SCREWS.
YOU’RE FINISHED!
CONSOLE
PRE-ATTACHED SCREWS
CONSOLE WIRES
CONSOLE MAST
3.0_4.0 AE_Rev.1.6.indd 14-15 8/27/07 3:36:41 PM