User manual

Installation of Custom Door Panels

This description concerns the model on which a decorative

door is installed.

① Loosen the anchor screws on the lower hinge of the door and

separate the door.

② Arrange the decorative door so that it matches the door of the

product.

③ Mark the center point of the top hinge and lower hinge holes that

extend over the overlay panel. Then drill 3/8” diameter holes

1/4” deep at that point.

④ Remove the overlay panel from the door and tighten the two M4×8

truss head screws, securing the sheet metal bracket to the overlay

panel.

⑤ Separate the inside gasket of the door and fasten it by inserting

the four screws into the four holes at the corners.

⑥ Fix the supplied door anchor bracket at the lower ends of the door

and decorative door.

⑦ Affix the completed door on the upper and lower hinge and fasten

the anchor screws of the lower hinge.

⑧ Check the operation and door swing.

①

②

③

④⑤

⑥

⑦