Installation manual

May 2009 AfiFree Terminal 155i Installation Manual 33

Chapter 3 Mounting and Wiring

This chapter contains the following procedures:

 Checking Jumpers in the Plug-in Connection Box (below)

 Mounting the Connection Box (page 34)

 Mounting and Wiring the AfiFree Body (page 34).

 Mounting and Wiring Terminal 155i (page 39)

 Wiring the Power Cable (page 42)

 Wiring the Solenoids (page 43)

 Wiring the Pulsator (page 44)

 Mounting and Wiring an External Start Button (page 45)

 Wiring the Communication Cable (page 47)

 Installing a Shut-off Valve Using the Valve installation kit for AfiFree (page 48)

 Mounting and Wiring the Wash Controller (page 50).

 Mounting the Wash Control Valve (page 54).

 Installing the Vacuum Line for the Wash Control Valve (page 55)

Checking Jumpers in the Plug-in Connection

Box

The Plug-in Connection Box has four sets of jumper pins, JP1, JP2, JP3, and JP4.

1. Remove the right-hand side cover of the Plug-in Connection Box and take the

PCB out of the box.

2. Make sure the jumpers are connected as in Table 6.

Table 7: Jumper Configuration in Plug-in Connection Box

Jumper Set

Pins Connected

JP1

JP2

JP3

1 and 2

JP4

1 and 2