Installation manual

46 Chapter 3 Mounting and Wiring P/N 9040322
 Installations using AfiFree Connection Boxes—see Wiring to an AfiFree
Connection Box (below)
 Installations using AfiMilk Pre-wired External Start Buttons with PICBs—see
Connecting an AfiMilk Pre-wired External Start Button (below)
 Installations using non-AfiMilk external start buttons with PICBs—see
Connecting a Non-AfiMilk External Start Button to a Plug-in Connection Box
(page 46)
Wiring to an AfiFree Connection Box
Wire the Cluster Removal Solenoid and the Vacuum Shut-off Sweep Solenoid to the
connection box according to Figure 17.
Connecting an AfiMilk Pre-wired External Start Button
Plug the external start button’s cable into socket 12 of the PICB.
Connecting a Non-AfiMilk External Start Button to a Plug-in Connection
Box
Wire a non-AfiMilk external start button as follows:
1. Cut off the external start button connection cable’s unused wires (Table 8) and
isolate them from electrical connection.
2. Wire the red and brown wires to the Normally Open contacts of the external start
button.
3. Plug the connector of the External Start Button Connection Cable into socket 12
of the PICB.
Table 10: Wiring a Non-AfiMilk External Start Button
Color of Wire on Connection
Cable
(P/N 4097309)
Function of Wire
Yellow
Future use
Black
Green
Red
Normally Open contact
Brown