Installation manual

50 Chapter 3 Mounting and Wiring P/N 9040322
Bolt
Vacuum NO Operated
Shut-off Valve
Generic Shut-off
Valve Bracket
Generic Shut-off
Valve Holder
Hexagon Socket
Screw
Washer
Washer
M6 DIN 9021
Air/Vacuum NC Operated
Shut-off Valve
Washer
Spring Lock
Washer
Nut
Figure 26: Mounting Shut-off Valve for AfiFree Body—Milk Inlet on Right
Mounting and Wiring the Wash Controller
Mounting and Wiring the Wash Controller has the following parts:
 Mounting the Wash Controller (below)
 Wiring the Wash Controller and Setting DIP Switches (page 52)
Mounting the Wash Controller
The Wash Controller can be installed using mounting plates (P/N 4088016) or
directly screwed to a suitable surface
The mounting plates can be attached to the Wash Controller with the mounting points
above or below the Controller. Selection of the attachment method depends on the
location and type of surface available (wall, beam or other surface).
The mounting plates protrude 6.5 cm (2
5
/
8
‖) from the edge of the Controller. Use M6
screws of a suitable length to secure the mounting plates to the wall or beam.