Installation manual

66 Chapter 4 System Configuration P/N 9040322
Loading Software and Parameter Values
NOTE
This procedure uploads software first to the AfiFree155 body, then to the
Terminal 155i. This includes upload of AfiFree 155i parameter values.
If you want to change any AfiFree 155i parameter value in
AfiSheep/AfiGoat from its default before uploading to the milk meter, see
Entering a Parameter Value in AfiSheep/AfiGoat, page 81.
For a description of the parameters, see Introduction to the AfiFree 155i
Parameters, page 74.
1. In AfiSheep/AfiGoat, make sure that Auto Program is enabled (see To enable
Auto Program: page 80)
2. In the AfiMen Real Time window, select the Track tab
3. Make sure that the milk station is in session.
If the station is not in session, click Continue to put it in session.
4. Select the Milk tab.
5. Click PARAMETER.
The Milk Parameters dialog box (Figure 34) appears.
6. Set the Automatic Load Software parameter value to 1:
7. Click Stop or Auto.
▪ In a shared parallel parlor, software upload begins automatically after 15
seconds.
▪ In a parallel parlor with entrance identification, software upload begins after
you open the exit gate.
NOTE
A display starting with an E (e.g., E074) indicates a malfunction during
software upload (caused by communication or power failure, etc.). For
recovery procedure, see Recovering from a Malfunction during Data
Upload, page 67.
During software upload to the AfiFree155 body, the following cycle of
indications appears on the display several times:
During software upload to the Terminal 155i, the following appear on the
display:
▪ LOad
▪ Strt
▪ A sequence of numbers, increasing in value by one approximately every
second:
and so on.