Installation manual

May 2009 AfiFree Terminal 155i Installation Manual 77
Setting Parameters from Terminal 155i
The procedures in this section make use of the information in Table 19 (page 74).
Some of these parameters can also be set from AfiSheep/ AfiGoat.
Reading and Setting Parameters
1. On the Terminal 155i, press the appropriate key combination specified in Table
19 (page 74).
The Animal ID field displays the parameter (on the left side) and current value
(on the right side). For example:
.
2. To change the value, press the Edit/ Message mode button .
3. To increase the value, do one of the following:
▪ To increase the value by the amount indicated in the Step column, press and
release .
▪ To increase the value by 10x the amount indicated in the Step column, press
for several seconds.
4. To decrease the value, do one of the following:
▪ To decrease the value by the amount indicated in the Step column, press and
release .
▪ To decrease the value by 10x the amount indicated in the Step column, press
for several seconds.
5. Perform the appropriate action of the following:
▪ To confirm a changed value, press the Enter button .
▪ To keep the current value, press the Cancel button .
Central Activation of Milking/Cleaning Mode
NOTE
Before you perform this procedure, see Group Retrieval (below). This
option is available only under AfiSheep/ AfiGoat.
At the start of a milking, when all of the milk meters are in cleaning mode, press
simultaneously "Group Nº " +"2"on one of the milk meters. All Milk Meters on the
same side will change mode from Cleaning to Stand By.
At the end of a milking, press simultaneously "Group Nº "+"8" on one of the milk
meters. All Milk Meters on the same side will change mode from Removal to
Cleaning.