Installation manual

90 Chapter 6 Corrective Maintenance P/N 9040322
Installing a Replacement AfiFree body
1. Mount the new AfiFree body as in Mounting the AfiFree Body (page 37).
2. Connect the hoses to the new AfiFree body.
3. Connect the pig-tail of the new AfiFree body to the AfiFree body connection
cable.
Replacing a Terminal 155i
CAUTION
When replacing several Terminal 155i’s, always start with the
malfunctioning unit that has the lowest identification number. Make sure
that its replacement is fully functioning before you replace the
malfunctioning Terminal 155i that has the next lowest identification
number.
There are three steps to replacing a Terminal 155i:
1. Preparing the Computer (below). This step prepares the computer to:
▪ Assign the original identification number to the new AfiFree155i unit
▪ Download the software (including parameter values)
2. Removing a Malfunctioning Terminal 155i (page 91)
3. Installing a Replacement Terminal 155i (page 91)
Preparing the Computer
1. In AfiSheep or AfiGoat, make sure that Auto Program is enabled.
2. Choose from:
Is AfiMen running?
Do this:
Yes
On the taskbar double-click
No
Open AfiMen
3. Verify that the parlor is active (AfiMen program is in a time track) and the
milking icon is displayed.
The AfiMen program is active during the designated milking times. If it is not
active, select the Track tab and click Start or Continue and then OK.
4. Click .
The Milk Parameters dialog box appears.
5. Verify that AfiMen is in Auto mode.
6. Make sure the following parameters are enabled: