Operation Manual

``
24
(Numbers refer to Figures 6 and 7)
Hazard button
(1.16)
The Hazard button activates the hazard lights (i.e., both indicators and
the
front and rear blinkers).
When the hazard lights are activated, all
three
LEDs (5.3, 5.4, 5.6) flash.
To turn off the hazard lights, press the button again.
Lock-out while
charging
When the Breeze C is being charged it is in lock-out mode. In this
mode it cannot be driven.
After stopping
After stopping the Breeze C, turn the key switch (1.17) to OFF and
remove the key. The
green LED will turn off .
Note:
The EMB locks automatically when the throttle control lever
is
released and the Breeze C has come to a complete stop.
Safe driving
When driving on ramps, high curbs and on sharp turns, drive very
slowly and carefully,
preferably with the speed set to MIN.
When going up or down a step
, always drive so that the wheels
are
fully
perpendicular to the step and both of the rear wheels
meet the
step at the same time
.
Never try to
go on an obstacle that is more than the maximum
recommended slope
or curb height (
see the stabilities and the obstacle
climbing
specifications given in Appendix A – Specification Sheet)
Always drive carefully
and adjust your speed to the road
conditions
.
Before making sharp turns, reduce speed to minimum to prevent
side roll-over.
Climbing an
obstacle
To climb an obstacle, drive the Breeze C forward toward the obstacle
until the front wheel
touches the obstacle, then, maintaining your
direction, increase speed.
Driving on
slopes and
turns
Before making sharp turns, particularly on
inclines
, reduce speed to minimum to prevent
side roll
-over.
The
Breeze C is able to go up slopes steeper
than the recommended safe slope.
Do not drive on
includes where you are not
sure about
the degree of slope. Always drive
very slowly
on inclines, and be sure not to
approach the incline side
-on (fully forward
only).
Prior to use
After reading through this entire manual and before using the
Breeze
C, do a visual check o
f all the parts of the vehicle, to make sure
that there is no visible damage. If you have any questions or concerns,
contact your dealer.
Controller
programming
Several parameters of the Breeze C controller can be programmed.
Programming
must be done by trained authorized technician only.
Incorrect
programming can cause abnormal operation of the Breeze C
and may result in damage and personal injury.