User manual

``
23
(Numbers refer to Figures 6 and 7)
LCD
DisplayKey
When driving and operating the Breeze S, all the required information
is displayed on the LCD screen (1.1).
See details below.
Battery status
Indicator
The Battery Capacity Indicator (5.5) on the LCD screen, displays the
remaining battery capacity. Like petrol gauges in cars, the indicator is
not absolutely accurate; it is merely a guide to help stop you running
out of fuel. The accuracy of the indicator also depends on the type and
age of the batteries. When the indicator shows 2-3 bars, recharge
batteries as soon as possible.
When the indicator displays one blinking bar, recharge immediately,
you can only drive a short distance (3-4 km on level surface). The
accuracy of the battery indicator reading also depends on the type and
age of the batteries.
Fault indicator
The Breeze S is equipped with fault indication.
The fault indication appears as a flashing code of the battery indicator
as well as an error code on the LCD screen (5.5).
For further details see Breeze Maintenance Manual.
Light indicator
When the main lights are ON (front and rear) a sign will be lit (5.6).
Blinker
indicators
When the blinkers are ON, signs will be lit (5.3 and / or 5.4).
Half speed
indicator
When the Half Speed switch (1/2) is at the Half Speed position, a sign
of "1/2" will be lit (5.11).
Alarm indicator
When one of the following conditions exists: Motor overheating, panic
brake was operated or manual release brake is in the OPEN position or
electric EMB is opened, the alarm indicator will be lit (5.13).
Speed display
(5.12)
The LCD screen digital area will display the speed of the Breeze S.
The speed is shown in kph or mph. The setting can be done by a
technician.
MODE and
RESET button
The MODE / RESET button (5.20) will change the digital reading from
Speed to Travel Distance or Time. The distance is showed in km. or
miles and the time displayed in hours.
(Note: Setting the speed unit can be done by a technician.
When you push the MODE button to the modes: "travel time" and
"travel distance" and keep pushing it for more than 7 seconds, the
"travel time" and "travel distance" will reset to zero.
Setup button
The Setup button 5.21 is used to set the clock.