User manual

``
24
Clock setup
When changing to clock mode with MODE the button, press it for 7
seconds and you will enter the Setup mode of the clock.
Adjusting the clock :
Use the left Setup button and the right Mode button as follows:
Every push on Mode changes the time unit and the selected unit
flashes.
During the flashing, every push on Setup increases 1 unit.
Stage
Display
Flashing
1
HH:mm
mm
2
HH:mm
HH
3
DD.MM or MM.DD
DD
4
DD.MM or MM.DD
MM
5
20YY
YY
6
Saving the updated time and date
6.3 DRIVING AND GENERAL USE
Climbing an
obstacle
To climb an Obstacle, drive the Breeze S forward toward the obstacle until
the front wheel touches the obstacle, then, maintaining your direction,
increase speed.
Driving on
slopes and
turns
Before making sharp turns, particularly on
inclines, reduce speed to minimum to
prevent side roll-over.
The Breeze S is able to go up slopes
steeper than the recommended safe
slope. Do not drive on includes where you
are not sure about the degree of slope.
However drive very slowly and avoid side
angles higher than 26% (15°).
Prior to use
After reading through this entire manual and before using the Breeze S,
do a visual check of all the parts of the vehicle, to make sure that there is
no visible damage. If you have any questions or concerns, contact your
dealer.
Controller
programming
Several parameters of the Breeze S controller can be programmed.
Programming must be done by trained authorized technician only.
Incorrect programming can cause abnormal operation of the Breeze S and
may result in damage and personal injury.