User manual

``
27
CHAPTER 8 – MAINTENANCE
Note:
1. Maintenance Manual is available for trained technicians.
2. The numbers in parentheses refer to the parts illustrated in figure 11.
Although the Breeze S requires very little maintenance, do not neglect it. When performing
maintenance procedures on the Breeze S, make sure that it stands on a level surface and
that the key is not inserted.
Periodic Maintenance Procedures
 Remark: For periodic maintenance, no special tools are needed.
No.
Type of Service
Frequency
2
Check air pressure in all tyres.
Every week
1
Check emergency brakes
Every week
3
Check normal driving and stopping
Every Month
4
Check tyre wear
Every Month
5
Check for missing and damaged parts
(see Figures 1 through 4).
When first receiving the Breeze S
or after a long time without using it.
6
Check that all screws and parts are
secure
Once a year by technician.
7
Replace batteries
 Every 2-3 years,
 After about 300-400 full cycles of
charge/discharge,
 When the distance you can
travel on a single charge
becomes short, or
 after a technician recommends
replacing it.
Note: To replace the batteries, the seat and the battery cover (which is located
under the seat) must be removed.
8
Cleaning
External – when needed.
Internal – Once a year by
technician.
As-required Maintenance Procedures
Type of Service
Frequency
Removing the seat and
the Batteries Cover (2)
Turn the seat by turning the lever (7.5) 45º (either direction).
The seat can be removed only at this angle.
Removing the seat (7) Holding the seat with one hand on the
backrest and the other at the front, lift it off the seat-mounting
post.
Warning! The seat weighs 20 kg (44 lbs).
The seat must be lifted by two people or by adequate lifting
equipment. Replace the battery cover, re-install it over the seat-
mounting post and make sure it is seated properly, then secure
it with the five screws.
Removing and
replacing the battery
cover (2)
To replace the battery cover, re-install it over the seat-mounting
post and make sure it is seated properly, then secure it with the
four screws (2.6).