Operation Manual

27
5.3 DRIVING AND GENERAL USE
Climbing an
Obst
acle
To climb an Obstacle drive the Breeze S forward, toward the
Obstacle
. Drive until that the front wheel is touching the
obstacle and than
squeeze the lever speed, keeping the
direction.
Driving on slopes
and Turns
Before making s
harp
turns
, and especially on
slopes,
reduce the
Breeze S
speed to
minimum to prevent
side roll
-over.
The
Breeze S is able to
go up slope higher than
the recommended safe
slope. Do not drive on
slopes you are not sure
about their angle.
However drive very
slowly and prevent s
ide
angles more than 26%
(15°).
Pre-use
Now after learning through all the operating instructions,
before starting to use the
Breeze S, do a visual check
through the all the parts of the vehicle, to make sure that no
external damage has been occur to the
vehicle while
transportation. In any case you are not sure call your dealer
and ask for an explanation.
Controller
Programming
Several parameters of the Breeze S Controller can be
programmed with a special Programmer.
Programming should be done by traine
d authorized
technician only. Wrong programming can cause abnormal
operation of the Breeze S ,Harm persons and Injury.
Performance
check
It is very much recommended that when receiving as new or
from another user or after a period of not using the
Breeze S
a performance check will be made as follows:
1.
Switch on the main switch.
2.
See that on the display panel –
the battery indicator is lit
and the Ready/ON led is lit as well.
3.
Squeeze the speed Wig Wag lever slowly and make sure
that the Breeze S is traveling
with correspondence to the
squeezing on the lever.
4. Release the Speed lever and make sure that the Breeze