Operation Manual

32
Replace
Batteries
Remove batteries terminal insulating cap. Each time remove
only one cap. Unsecure the screw of the wiring terminal from
battery terminal using
10/13 mm key. Make sure your 10/13
mm key is not touching any other terminal or metal part. This
can cause damage and Injure.
After un securing all wires
terminals
, remove the batteries and
install the new ones.
Connect the wires as shown in below
F
igure 12. The connection Label is also located near the
batteries.
Secure
all wires to the frame with Ties as shown in Figure 1
2.
Secure all terminals with screws and make sure insulating caps
are correctly placed on terminals.
Warning!
Batteries contain high energy. Misconnection, short
circuits can burst with strong sparks causing heat and possible
fire.
Warning!
Working with batter
ies can cause damage and Injure
if not done properly.
Note
! Replacing batteries should be done only by trained
and
or professional person.
Figure 12