Installation Guide
Table Of Contents
- About this Guide and Scope
- Intended Users
- Conventions
- Safety
- High Power Safety Precautions
- 1 Introduction
- 2 Prerequisite Considerations
- 3 Ordering Components
- 4 Understanding Installation Workflow
- 5 Mounting the Components
- 6 Laying the Cables
- 7 Wiring the System
- 8 Setting AfiPass II Addresses and Calibrating Antennas
- 9 Configuring the System
- 10 Using AfiPass - First Time
- 11 Identifying Faults and Troubleshooting
- APPENDIX 1
- APPENDIX 2 – DIP Switch
- Certification
9
For Technicians | AfiPass II Installation Guide
4 Understanding Installation Workflow
Lay the cables (see Chapter 6).
Wire the system (see Chapter 7).
First time use (see Chapter 10).
Mount the devices (see Chapter 5).
Set Device Addresses and Antenna Calibration
(see Chapter 8).
Configure AfiPass II in AfiControl (see Chapter 9).