Installation Guide
Table Of Contents
- About this Guide and Scope
- Intended Users
- Conventions
- Safety
- High Power Safety Precautions
- 1 Introduction
- 2 Prerequisite Considerations
- 3 Ordering Components
- 4 Understanding Installation Workflow
- 5 Mounting the Components
- 6 Laying the Cables
- 7 Wiring the System
- 8 Setting AfiPass II Addresses and Calibrating Antennas
- 9 Configuring the System
- 10 Using AfiPass - First Time
- 11 Identifying Faults and Troubleshooting
- APPENDIX 1
- APPENDIX 2 – DIP Switch
- Certification
17
For Technicians | AfiPass II Installation Guide
Placement of Components
Example 1 Layout: Figure 3 shows the default system layout for a 2X12 Parallel parlor, where the
number of stalls does not divide equally into groups of 5. The excess stalls on each side of the parlor
are connected by default to a common device for both sides at the end of the parlor. This device is
addressed as the last device in the parlor.
Figure 3 - Default Device Addressing of a 2X12 Parallel/HB Parlor