Installation Guide
Table Of Contents
- About this Guide and Scope
- Intended Users
- Conventions
- Safety
- High Power Safety Precautions
- 1 Introduction
- 2 Prerequisite Considerations
- 3 Ordering Components
- 4 Understanding Installation Workflow
- 5 Mounting the Components
- 6 Laying the Cables
- 7 Wiring the System
- 8 Setting AfiPass II Addresses and Calibrating Antennas
- 9 Configuring the System
- 10 Using AfiPass - First Time
- 11 Identifying Faults and Troubleshooting
- APPENDIX 1
- APPENDIX 2 – DIP Switch
- Certification
21
For Technicians | AfiPass II Installation Guide
Cable Type Specification From To P/N
Maximum
Cable Length
RF Signal Cable Prewired to the antenna Antenna AfiPass II
15m
(Do not reduce
the cable
length to less
than 3m)
To lay the cables:
1. Lay the communication cable between the AfiPass II Controller and the computer.
2. Lay the communication cables between all the AfiPass II Controllers at the parlor.
3. Lay the power cable from the power transformer towards the AfiPass II Controllers.
4. Lay the prewired antenna cables from the antenna towards the AfiPass II controller.
Note: You can cut the cable to size to avoid slack. Minimum cable length = 3 meters.
Cable length less than 3 meters may affect optimal antenna resonance resulting in decreased
ID range and a possible malfunction of the system.