Installation Guide
Table Of Contents
- About this Guide and Scope
- Intended Users
- Conventions
- Safety
- High Power Safety Precautions
- 1 Introduction
- 2 Prerequisite Considerations
- 3 Ordering Components
- 4 Understanding Installation Workflow
- 5 Mounting the Components
- 6 Laying the Cables
- 7 Wiring the System
- 8 Setting AfiPass II Addresses and Calibrating Antennas
- 9 Configuring the System
- 10 Using AfiPass - First Time
- 11 Identifying Faults and Troubleshooting
- APPENDIX 1
- APPENDIX 2 – DIP Switch
- Certification
27
For Technicians | AfiPass II Installation Guide
Connectors and Functions
Wire the cables in the following order:
1. Connect the antenna signal cables, using ferrule type terminators, as follows:
2. Connect the shield wire of the antenna's Coax cable to ANTx Pin 1 (18AWG Ferrule
connector).
3. Connect the signal wire of the antenna's Coax cable to ANTx Pin 2 (16AWG Ferrule
connector).
Figure 8 – Antenna Signal Cables Wiring
Figure 9 – Antenna Signal Cable Connectivity
Note: If the cable is cut to size, make sure to use ferrule type terminators as described above.
Do not expose the wires more than 1.5 cm (0.6 inches)Figure 8.
Bend the ferrule type terminators slightly towards the cable outlet to avoid exposed wires
coming into contact with the Display panel's PCB when the lid is closed. Make sure to leave as
little cable slack as possible (see Figure 9).