Installation Guide
Table Of Contents
- About this Guide and Scope
- Intended Users
- Conventions
- Safety
- High Power Safety Precautions
- 1 Introduction
- 2 Prerequisite Considerations
- 3 Ordering Components
- 4 Understanding Installation Workflow
- 5 Mounting the Components
- 6 Laying the Cables
- 7 Wiring the System
- 8 Setting AfiPass II Addresses and Calibrating Antennas
- 9 Configuring the System
- 10 Using AfiPass - First Time
- 11 Identifying Faults and Troubleshooting
- APPENDIX 1
- APPENDIX 2 – DIP Switch
- Certification
31
For Technicians | AfiPass II Installation Guide
Figure 15 – Wiring Example of the Main Display Device
Figure 16 – Wiring Example with Grounding
7.5 Finalizing the Wiring Connections
To finalize the wiring connection after connecting the wires to the connectors:
1. Adjust the cables to an appropriate length inside the box.
2. Tighten the grommet nuts.
3. Make sure the box closes properly.