Installation Guide
Table Of Contents
- About this Guide and Scope
- Intended Users
- Conventions
- Safety
- High Power Safety Precautions
- 1 Introduction
- 2 Prerequisite Considerations
- 3 Ordering Components
- 4 Understanding Installation Workflow
- 5 Mounting the Components
- 6 Laying the Cables
- 7 Wiring the System
- 8 Setting AfiPass II Addresses and Calibrating Antennas
- 9 Configuring the System
- 10 Using AfiPass - First Time
- 11 Identifying Faults and Troubleshooting
- APPENDIX 1
- APPENDIX 2 – DIP Switch
- Certification
34
For Technicians | AfiPass II Installation Guide
8.2 Setting Device Addresses
Each AfiPass II Controller must be set with its own address number.
Note: The AfiPass II Controller Main Display Device must be set as Address 1 to display
currently active antenna for the whole parlor, and the status of entry and exit gates.
When configuring the Main Display Device, disconnect the gate cables. Once your activity is
complete, reconnect the gate cables.
To set the device address:
1. On the Technician Tool, turn OFF TS1 and TS2.
2. On the SW1 Config. Dip Switch, turn ON SW1.3 (address switch).
Indication: The display shows 'ADR T'.
3. Click PB1 or PB2.
Indication: The display shows the current address of the device 'ADR XX'.
4. Press PB1 and PB2 simultaneously.
Indication: Sound is emitted for 4 seconds. The display flashes the current address of the
device 'ADR XX'.
5. Change the address by pressing PB1 (increment by 1) or PB2 (decrement by 1).
Note: A long press on PB1 or PB2 will increase/decrease the value by 10.
6. Press and hold PB1 and PB2 simultaneously for 3 seconds to set the address.
Indication: Sound is emitted for 4 seconds. The display flashes the current address of the
device 'ADR XX'.