Installation Instructions

Fault Identification and Troubleshooting
Chapter
9
Oct 2013
AfiAct II™ Installation Manual128
The process is simple, and requires only that the user set the Reader’s host static IP
in the laptop NIC; then user may access the Luci interface.
Method:
Connect the Reader directly to your laptop:
1. Open the Reader box and connect a network cable to the NIC.
2. Connect the other side of the network cable to the laptop Ethernet port.
3. In the laptop, set the connected NIC to use static IP 172.20.1.10 and subnet
mask 255.255.255.0. This procedure varies according to the laptop’s Operating
System. For example, instructions for the Windows 7 operating system are
provided in Appendix A
4. After laptop's NIC is set to use static IP, then follow instructions on section 5.3
(you may now communicate with the Reader via the laptop, via the Luci
interface. It is now possible to have access to the available wireless networks,
and obtain connection).
9.6 Region Transmission Setup
Description:
Region transmission setup is wrong.
Suggested solution:
Set the Reader transmission area and channel via the RT System tool, see 4.3.3
9.7 AfiFarm Installation Problems
Description:
A problem occurs during the AfiAct software installation.
Most probable cause:
The system pre-requisites were not fully performed.
Suggested solution:
Review the system installation pre-requisites, see 2.4.