Installation Instructions

Preface

Oct 2013

AfiAct II™ Installation Manual

iii

Notes

This device complies with FCC Rules Part 15 and with Industry Canada license-

exempt RSS standard(s). Operation is subject to two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept any interference that

may be received or that may cause undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux

appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions

suivantes :

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même

si le brouillage est susceptible d'en compromettre le fonctionnement.

NOTE: The digital circuit of this device has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

x Reorient or relocate the receiving antenna.

x Increase the separation between the equipment and receiver.

x Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

x Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this equipment not expressly approved by the party

responsible for compliance (Afimilk Ltd.) could void the user’s authority to operate

the equipment.

WARNING

To comply with FCC RF exposure compliance requirements, the

antenna used for this transmitter must be installed to provide a

separation distance of at least 20 cm from all persons and must not be

co-located or operating in conjunction with any other

antenna or

transmitter.