Installation Instructions

Preface

Oct 2013

AfiAct II™ Installation Manual

x Afimilk recommends that the customer call for a full system inspection

by a qualified technician authorized by afimilk every six months.

x It is the responsibility of the operator to install, operate, and maintain

the system in accordance with all applicable laws, codes and regulations.

x The equipment must be used only for the described purpose.

x This system has been checked for viruses prior to supply. If in the course

of a service call, a virus is detected, removal of the virus, and any

software or hardware repairs resulting from it, will be charged to the

purchaser.

x The system and its components are powered by electricity from a main

power supply. To avoid personal injury, danger of fire, and possible

damage to equipment and materials, all work on electrical and

electronic circuits should be done following these basic safety

procedures:

x Remove power from the circuit or equipment prior to working on it.

Never assume the circuit is off; check it with a multimeter.

x In case of electrical fire, switch off the circuit and report it immediately

to appropriate authority.

x Stay away from live circuits. Do not work on or make adjustments when

the power switch is on.

x Never switch on equipment in the presence of water leakage.

x Work in clean, dry areas. Avoid working in damp or wet locations

because this increases the chance of electrical shock.

x Wear only nonconductive shoes to lessen the possibility of electrical

shock.

x Remove all rings, wristwatches, bracelets, and similar metal items. Avoid

working in clothing that contains exposed metal zippers, buttons, or

other types of metal fasteners. The metal can act as a conductor, heat

up, and cause a bad burn.

x High voltage surges and other power irregularities can cause extensive

damage to a system. It is the responsibility of the operator to provide a

power protection system.