Setup guide

www.afinia.com

Unpackaging

for Windows and Mac OS X

Afinia H480 3D Printer

14.02.05

Unpacking Your Afinia 3D Printer

Your Afinia 3D Printer comes with the Installation Disc, Manual, Unpack and Setup Guide (this document),

and an Accessory Pack. Remove these items before removing the Printer from the box.

Carefully lift the Printer and foam from the box, removing the side foams while supporting the

printer.

Remove the foam between the Extruder and the printer.

There are two packaging clips on the Printer that are used to hold the platform and

extruder assembly in place during shipping. These clips must be removed before

the Printer is powered on.

Turn the Printer so the back is facing you.

The first clip will be just below the extruder

assembly, held in place with tape. Remove the

tape, then slide the clip down to remove it.

Save the packaging clips! It is highly recommended

that you reinstall these two clips if you need to ship the

Printer in the future.

The second clip is holding the Z-axis arm down. Gently lift the X-axis arm a few inches.

Do not lift the arm by the platform as this may affect the levelling of the platform!

Once the arm is raised, rotate the top of the clip towards the front of the Printer. The clip

will slide off the arm once it is in the correct position.

Accessory Pack Contents

Next, open the Accessory Pack and verify the contents with those listed below:

You will need the Filament Hanger, Filament Spool, Filament Tube, Hex Wrenches, Power Supply and Power Cable, and USB

Cable to complete the Hardware Setup and Installation. Please follow the instructions on the other side of this document.

For more detailed information on the Setup and Installation process, please review the Afinia 3D Printer User’s Manual.

1. USB Cable

2. Platform Probe and Data Cable

3. Filament Guide Tube

4. Filament Hanger

5. Nozzle Wrench & Hex Wrenches

6. Spare screws & washers

7. Tweezers

8. Exacto Knife and blades

9. Snipping Pliers

10. Putty Knife

11. FR-4 (Perf) Board

12. Gloves (1 pair)

13. Spool of Filament (1, Natural)

14. Power Cable

15. Power Supply

PAGE 1
Afinia H480 3D Printer Unpackaging for Windows and Mac OS X Accessory Pack Contents Next, open the Accessory Pack and verify the contents with those listed below: Unpacking Your Afinia 3D Printer Your Afinia 3D Printer comes with the Installation Disc, Manual, Unpack and Setup Guide (this document), and an Accessory Pack. Remove these items before removing the Printer from the box. Carefully lift the Printer and foam from the box, removing the side foams while supporting the printer.
PAGE 2
Afinia H480 3D Printer Installation & sETUP Guide for Windows and Mac OS X To install and set up your Afinia 3D Printer, please follow these steps: For more information, please see the Afinia 3D Printer User’s Manual! C. Once the nozzle is heated, push the filament into the hole at the top of the extruder head and hold it there with gentle pressure until the extruder motor starts pulling it through the extrusion head. The extruder will extrude a thin filament of material for a short period of time. 1.