User's Manual

4 AFINIA3DSOFTWAREINSTALLATION
4.1 Windows
Start the setup.exe file and install it to the specified directory (Default
is “Program files/Afinia” or for 64bit computers "Program files
x86/Afinia”). Refer to the trouble shooting section for further help.
4.2 MAC
Run the Afinia Mac Setup.pkg file to install the
software. Refer to the trouble shooting section for
further help.
5 INITIALIZE
Every time you switch on the printer or perform an emergency stop on a print you'll need to initialize the
printer. Doing an initialization zeros each axis to the printers starting point. For example if the print head
crashed into a model, the head could slip on the belt and you would then need to stop the print and
initialize. This can be done using either the touch panel or Afinia software.
TOUCH PANEL SOFTWARE
Click 3D Print
then Initialize.
Note: This install includes the Afinia
software, the Afinia drivers, spare part
files and firmware into your Program
files/Afinia folder.
If you have any problems with the MAC software try:
1. Navigate to /Applications/Utilities/ and open Disk Utility.
2. Select the hard drive the software is installed on.
3. Click on the Repair Disk Permissions button.