Instructions / Assembly
Table Of Contents
- How to use this manual
- Contents
- DO NOT OPERATE THE SCOOTER BEFORE READING AND UNDE
- WARNING
- Intended Use
- Assembly
- Battery Charging
- Typical Use
- Control Functions
- Transporting
- TIP:
- Important:
- Getting on to your scooter
- Getting off your scooter
- Hand Controls
- The Preset Speed Knob
- The Battery Gauge
- TIP:
- Operating the Lights
- Throttle Lever
- Horn Button
- Key Switch
- Off Board Charging Socket
- WARNING.
- WARNING:
- Removing the Seat
- Note: Exercise caution when lifting the seat.
- Seat Adjustment
- Armrest Adjustment
- Tiller Adjustment
- Battery Removal
- Battery Replacement
- Off-Board Battery Charger
- Note:
- 1.RED = Power is on.
- The off-board charger must be kept dry in temperat
- Packaging
- Important
- Transportation
- TIP:
- Packaging and transportation environment condition
- Basic Driving
- Important:
- Traveling across slopes
- Do not traverse across the face of a slope in exce
- Note: Automatic braking is not instantaneous and w
- Switching off
- Use on the footpath
- P12.4
- Crossing roads
- Note: Low speed settings are recommended when trav
- Use of mobile phones
- Tyres
- Emergency Braking
- Caution!
- Freewheel mechanism
- General information
- Batteries
- Maintenance free
- Battery care
- Battery pack care plan
- Do not leave the charger still connected to the ba
- Caution
- Caution!
- The range of your vehicle
- Note: If you are out on your scooter and the batte
- We specifically disclaim responsibility to all per
- Attention: Switch on the scooter lights (if fitted
- Failure to comply with the above requirements coul
- This scooter has been tested to ISO 7176 Part 9 “C
- Maximum User Weight Limitations.
- DISPOSAL
- CAUTION:
- EMC sources can be broadly classified into three t
- Note: Other types of hand-held devices such as cor
- Note:
- Notes:
- Warnings
- Attachments：
- Storage
- Electronic faults
- Wheels
- Warranty condition
34
Warnings
This device or system should be kept away from other equipments. If
they must be put together, pls check whether the device or system can
run normally.
You should consider the original manufacturer of the device or system
as the sole supplier. Failure to do so may cause EMC increase and or
decrease anti-EMC ability.
Attachments：
Guidance and manufacturer’s Declaration–electromagnetic
emission
（SW-1000Sscooter）is intended for use in the electromagnetic
environment specified below. The customer or the user of the
（SW-1000Sscooter） should assure that it is used in such an
environment.
Emission Test
Compliance
Electromagnetic
environment–guidance
RF Emission
CISPR 11
Group 1
(SW-1000Sscooter) use RF
energy only for its internal
function. Therefore, it’s RF
emissions are very low and
are not likely to cause any
interference in nearby
electronic equipment.
RF Emission
CISPR 11
Class B
(SW-1000Sscooter) is
suitable for use in all
establishments, including
domestic establishment and
those directly connected to
the public low-voltage power
supply network that supplies
buildings used for domestic
purposes.
Harmonic Emissions
IEC 61000S-3-2
Class A
Voltage
fluctuation/flicker
emissions
IEC 61000S-3-3
complies