Instructions / Assembly
Table Of Contents
- How to use this manual
- Contents
- DO NOT OPERATE THE SCOOTER BEFORE READING AND UNDE
- WARNING
- Intended Use
- Assembly
- Battery Charging
- Typical Use
- Control Functions
- Transporting
- TIP:
- Important:
- Getting on to your scooter
- Getting off your scooter
- Hand Controls
- The Preset Speed Knob
- The Battery Gauge
- TIP:
- Operating the Lights
- Throttle Lever
- Horn Button
- Key Switch
- Off Board Charging Socket
- WARNING.
- WARNING:
- Removing the Seat
- Note: Exercise caution when lifting the seat.
- Seat Adjustment
- Armrest Adjustment
- Tiller Adjustment
- Battery Removal
- Battery Replacement
- Off-Board Battery Charger
- Note:
- 1.RED = Power is on.
- The off-board charger must be kept dry in temperat
- Packaging
- Important
- Transportation
- TIP:
- Packaging and transportation environment condition
- Basic Driving
- Important:
- Traveling across slopes
- Do not traverse across the face of a slope in exce
- Note: Automatic braking is not instantaneous and w
- Switching off
- Use on the footpath
- P12.4
- Crossing roads
- Note: Low speed settings are recommended when trav
- Use of mobile phones
- Tyres
- Emergency Braking
- Caution!
- Freewheel mechanism
- General information
- Batteries
- Maintenance free
- Battery care
- Battery pack care plan
- Do not leave the charger still connected to the ba
- Caution
- Caution!
- The range of your vehicle
- Note: If you are out on your scooter and the batte
- We specifically disclaim responsibility to all per
- Attention: Switch on the scooter lights (if fitted
- Failure to comply with the above requirements coul
- This scooter has been tested to ISO 7176 Part 9 “C
- Maximum User Weight Limitations.
- DISPOSAL
- CAUTION:
- EMC sources can be broadly classified into three t
- Note: Other types of hand-held devices such as cor
- Note:
- Notes:
- Warnings
- Attachments：
- Storage
- Electronic faults
- Wheels
- Warranty condition
35
Guidance and manufacturer’s Declaration–electromagnetic
emission
（SW-1000Sscooter）is intended for use in the electromagnetic
environment specified below. The customer or the user of the
（SW-1000Sscooter） should assure that it is used in such an
environment.
Immunity test
IEC 60601
test level
Complia
nce
level
electromagnetic
environment-guidanc
e
Electrostatic
discharge
（ESD）
IEC 61000S-4-2
±6 kV contact
±8 kV air
±6 kV
contact
±8 kV air
Floors should be wood,
concrete or ceramic
tile. If floors are
covered with synthetic
material, the relative
humidity should be at
least 30%.
Electrical fast
transient/ burst
IEC 61000S-4-4
±2kV for power
supply lines
±1kV for input/
output lines
±2kV for
power
supply
lines
±1kV for
input/
output
lines
Mains power quality
should be that of a
typical commercial or
hospital environment.
Surge
IEC 61000S-4-5
±1 kV
differential
mode
±2 kV common
mode
±1 kV
differenti
al mode
±2 kV
common
mode
Mains power quality
should be that of a
typical commercial or
hospital environment.