Instructions / Assembly
Table Of Contents
- How to use this manual
- Contents
- DO NOT OPERATE THE SCOOTER BEFORE READING AND UNDE
- WARNING
- Intended Use
- Assembly
- Battery Charging
- Typical Use
- Control Functions
- Transporting
- TIP:
- Important:
- Getting on to your scooter
- Getting off your scooter
- Hand Controls
- The Preset Speed Knob
- The Battery Gauge
- TIP:
- Operating the Lights
- Throttle Lever
- Horn Button
- Key Switch
- Off Board Charging Socket
- WARNING.
- WARNING:
- Removing the Seat
- Note: Exercise caution when lifting the seat.
- Seat Adjustment
- Armrest Adjustment
- Tiller Adjustment
- Battery Removal
- Battery Replacement
- Off-Board Battery Charger
- Note:
- 1.RED = Power is on.
- The off-board charger must be kept dry in temperat
- Packaging
- Important
- Transportation
- TIP:
- Packaging and transportation environment condition
- Basic Driving
- Important:
- Traveling across slopes
- Do not traverse across the face of a slope in exce
- Note: Automatic braking is not instantaneous and w
- Switching off
- Use on the footpath
- P12.4
- Crossing roads
- Note: Low speed settings are recommended when trav
- Use of mobile phones
- Tyres
- Emergency Braking
- Caution!
- Freewheel mechanism
- General information
- Batteries
- Maintenance free
- Battery care
- Battery pack care plan
- Do not leave the charger still connected to the ba
- Caution
- Caution!
- The range of your vehicle
- Note: If you are out on your scooter and the batte
- We specifically disclaim responsibility to all per
- Attention: Switch on the scooter lights (if fitted
- Failure to comply with the above requirements coul
- This scooter has been tested to ISO 7176 Part 9 “C
- Maximum User Weight Limitations.
- DISPOSAL
- CAUTION:
- EMC sources can be broadly classified into three t
- Note: Other types of hand-held devices such as cor
- Note:
- Notes:
- Warnings
- Attachments：
- Storage
- Electronic faults
- Wheels
- Warranty condition
37
Conducted RF
IEC 61000S-4-6
Radiated RF
IEC 61000S-4-3
3 Vrms
150 kHz to 80
MHz
3 V/m
80 MHz to 2.5
GHz
3 Vrms
3 V/m
Portable and mobile RF
communications
equipment should be
used or closer to any
part of the
（SW-1000Sscooter）,
including cables, than
the recommended
separation distance
calculated from the
equation applicable to
the frequency of the
transmitter.
Recommended
separation distance
d =
1.2 P
d =
1.2 P
80 MHz
to 800 MHz
d =
2.3 P
800 MHz
to 2.5 GHz
Where P is the
maximum output power
rating of the transmitter
in watts(W) according
to the transmitter
manufacturer and d is
the recommended
separation distance in
the meters( m).b
Field strengths from
fixed RF transmitters,
as determined by an
electromagnetic site
survey, should be less
than the compliance
level in each frequency
range.
Interference may occur
in the vicinity of the
equipment marked with
the following symbol: