Instructions / Assembly
Table Of Contents
- How to use this manual
- Contents
- DO NOT OPERATE THE SCOOTER BEFORE READING AND UNDE
- WARNING
- Intended Use
- Assembly
- Battery Charging
- Typical Use
- Control Functions
- Transporting
- TIP:
- Important:
- Getting on to your scooter
- Getting off your scooter
- Hand Controls
- The Preset Speed Knob
- The Battery Gauge
- TIP:
- Operating the Lights
- Throttle Lever
- Horn Button
- Key Switch
- Off Board Charging Socket
- WARNING.
- WARNING:
- Removing the Seat
- Note: Exercise caution when lifting the seat.
- Seat Adjustment
- Armrest Adjustment
- Tiller Adjustment
- Battery Removal
- Battery Replacement
- Off-Board Battery Charger
- Note:
- 1.RED = Power is on.
- The off-board charger must be kept dry in temperat
- Packaging
- Important
- Transportation
- TIP:
- Packaging and transportation environment condition
- Basic Driving
- Important:
- Traveling across slopes
- Do not traverse across the face of a slope in exce
- Note: Automatic braking is not instantaneous and w
- Switching off
- Use on the footpath
- P12.4
- Crossing roads
- Note: Low speed settings are recommended when trav
- Use of mobile phones
- Tyres
- Emergency Braking
- Caution!
- Freewheel mechanism
- General information
- Batteries
- Maintenance free
- Battery care
- Battery pack care plan
- Do not leave the charger still connected to the ba
- Caution
- Caution!
- The range of your vehicle
- Note: If you are out on your scooter and the batte
- We specifically disclaim responsibility to all per
- Attention: Switch on the scooter lights (if fitted
- Failure to comply with the above requirements coul
- This scooter has been tested to ISO 7176 Part 9 “C
- Maximum User Weight Limitations.
- DISPOSAL
- CAUTION:
- EMC sources can be broadly classified into three t
- Note: Other types of hand-held devices such as cor
- Note:
- Notes:
- Warnings
- Attachments：
- Storage
- Electronic faults
- Wheels
- Warranty condition
46
Battery pack not engaged
properly
Check battery pack is
fully engaged onto
connectors
Charger plugged in
Unplug charger
Button on battery pack
popped out
Reset circuit-breaker
button
Disconnected loom or
plugs
Check all plugs &
looms
Control system fault
Contact dealer
Motor runs
irregularly
and/or noisily
Electrical malfunction
Contact dealer
Control system fault
Contact dealer
DO NOT ATTEMPT TO OPEN ANY PARTS OF THE SCOOTER
CONTROL SYSTEM, BATTERY PACK, LOOMS, PLUGS OR
BATTERY CHARGER.
THE CONTROL SYSTEM IS SAFETY CRITICAL AND THERE ARE
NO USER SERVICEABLE PARTS
Your scooter is fitted with a self diagnostic controller that will give a
sequence of audible beeps when an error is detected to help you, or the
authorized service agent, determine the drive electronics fault.
Should you switch on the scooter and hear the beeps note the number
of beeps, separated by a short delay between each sequence, and refer to
the table below.
NUMBER
OF
BEEPS
REPRES
ENT
POSSIBLE
CAUSE
SOLUTION
1
Battery
power low
Power not
enough
The battery needs
harging
2
Low
battery
voltage
Power not
enough
The battery needs
harging
3
High
battery
voltage
Too higher
voltage, while
overloading or
climbing
Decrease speed
while climbing
Check battery
connection