Instructions / Assembly
Table Of Contents
- How to use this manual
- Contents
- DO NOT OPERATE THE SCOOTER BEFORE READING AND UNDE
- WARNING
- Intended Use
- Assembly
- Battery Charging
- Typical Use
- Control Functions
- Transporting
- TIP:
- Important:
- Getting on to your scooter
- Getting off your scooter
- Hand Controls
- The Preset Speed Knob
- The Battery Gauge
- TIP:
- Operating the Lights
- Throttle Lever
- Horn Button
- Key Switch
- Off Board Charging Socket
- WARNING.
- WARNING:
- Removing the Seat
- Note: Exercise caution when lifting the seat.
- Seat Adjustment
- Armrest Adjustment
- Tiller Adjustment
- Battery Removal
- Battery Replacement
- Off-Board Battery Charger
- Note:
- 1.RED = Power is on.
- The off-board charger must be kept dry in temperat
- Packaging
- Important
- Transportation
- TIP:
- Packaging and transportation environment condition
- Basic Driving
- Important:
- Traveling across slopes
- Do not traverse across the face of a slope in exce
- Note: Automatic braking is not instantaneous and w
- Switching off
- Use on the footpath
- P12.4
- Crossing roads
- Note: Low speed settings are recommended when trav
- Use of mobile phones
- Tyres
- Emergency Braking
- Caution!
- Freewheel mechanism
- General information
- Batteries
- Maintenance free
- Battery care
- Battery pack care plan
- Do not leave the charger still connected to the ba
- Caution
- Caution!
- The range of your vehicle
- Note: If you are out on your scooter and the batte
- We specifically disclaim responsibility to all per
- Attention: Switch on the scooter lights (if fitted
- Failure to comply with the above requirements coul
- This scooter has been tested to ISO 7176 Part 9 “C
- Maximum User Weight Limitations.
- DISPOSAL
- CAUTION:
- EMC sources can be broadly classified into three t
- Note: Other types of hand-held devices such as cor
- Note:
- Notes:
- Warnings
- Attachments：
- Storage
- Electronic faults
- Wheels
- Warranty condition
47
4
electric
current
over limit
electric current
over limit of
motor
Check motor and
relative wiring
connections
Switch off and wait a
few minutes and
Switch on.
5
Freewheel
level issue
The freewheel
level is on
Check the relative
wiring of the
freewheel level
Confirm the level is
on the correct
position
6
Accelerate
the
variable
resistor
issue
When turning on
the controller,
accelerate variabl
e resistor isn’t
on the neutral
position
Make sure the
accelerate variable
resistor is on the
neutral position
Accelerate variable
resistor may need to
recalibration.
7
Speed
limited
variable
resistor
issue
accelerate variable
resistor, Speed
limited variable
resistor or other
wiring issue
Check all the
accelerate variable
resistor, Speed
limited variable
resistor or other
wiring
8
Motor
voltage
issue
Motor and other
relative wirings
issue
Check Motor and
other relative
wirings
9
Other
issues
Some inner
issues in the
controller
Check all the
connection and
wirings
10
Pushing/
Slipping
issues
The speed of
pushing or
slipping is over
limited
Switch off and on the
controller