User manual

Set the timer by selecting the element and press “MENU” button. The screen will display
‘MIN” use + and – buttons until the timer display shows the required number of
minutes. Maximum setting time is 99 minutes.
While in operation, you will NOT notice any change in the cooking zone. Induction
elements do not glow red.
5.To turn the element off, press the “ON/OFF” button
CAUTION: Even though the elements themselves do not generate heat, the surface
may become hot since it is in contact with a hot cookware.
Operation of the CERAMIC/INFRARED ( Right ) zones of the cooktop
1.Press the “ON/OFF” button to turn on the element of your choice.
The indicator lights will flash on the display to indicate Stand By /Ready to use mode. If
no cooking operation started within one minute it will revert to its previous status
2.Press the “POWER” button to show default set cooking power , 1000W for the small
zone and 1600W for the bigger heating element.
Press the + and – buttons to select alternative cooking zone power settings.
3.Two Ceramic zones equipped with 24 hours cut off timer. The timer automatically
switches an element off after a preset time.
To set up timer:
Select the element and press “TIMER” button. The display screen light with “ 00:00 ”
for “hours : minutes” to set up. Use + and – buttons to set up minutes and hours. Set
up minutes, with short touch for 1 minute intervals and longer touch is 5 minutes until
the timer display shows the required number of minutes. To set up hours press the
“TIMER” button again and use + and – buttons to set the hours. When complete, the 4
digits display will flash three times to confirm settings done and start count down.
To clear the timer, touch the ”TIMER” button again. The timer will clear and display will
revert to displaying the cooking power level.
4.To prevent accidental turning on by children or if cleaning, touch the “Child-lock”
button to lock the other buttons except “ON/OFF”; to unlock touch it twice.
5.To turn the element off, press the “ON/OFF” button. The “high temperature” lamp will
not go down until the glass surface of the cooktop cools down. Do not touch the heating
zone surface until this light is off
Note:
After the cooktop is switched off but still connected to the power, it will be in
“Stand by” mode. The indicator lights will flash on the digital display to indicate
the appliance is connected to the power supply and in ready to use status.
Safety features of the Ceramic cooking zones
Over heat protection. Operation is automatically stopped if the temperature of the
cooking surface reaches 650 °C
Inner temperature overheat protection. Operation is automatically stopped if the internal
temperature reaches 95 °C. Low/High voltage protection. Operation is automatically
stopped, if supply voltage is outside the range 95-275V