Instructions / Assembly

3
1. The LP-gas supply cylinder to be used must be constructed and marked in accordance with the U.S.
Deparment of Transportation (D.O.T.) Specifications for LP-Gas Cylinders, or the Standard for Cylinders,
Spheres and Tubes for Transportation of Dangerous Goods and Commission, CAN/CSA-B339, as
applicable.
2. The LP-gas supply cylinder to be used must have a listed overfilling prevention device (See Figure 1).
3. The LP-gas supply cylinder to be used must have a cylinder connection device compatible with the
connection for the appliance.
4. A self contained LP-gas cylinder for use with this appliance must have a capacity of 20 lbs cylinder (Height
about 18 in., Tank Body about dia12 in., Base about dia8 in.).
5. The cylinder supply system must be arranged for vapor withdrawl.
6. The cylinder used must include a collar to protect the cylinder valve.
7. This appliance shall be used only outdoors in a well-ventilated space and shall not be used in a building,
garage or any other enclosed space.
8. When this appliance is not in use, the gas must be turned off at the supply cylinder.
9. Storage of this appliance indoors is permissible only if the cylinder is disconnected and removed from the
Appliance.
10. Cylinders must be stored outdoors in a well-ventilated area out of the reach of children.Disconnected
cylinders must have threaded valve plugs tightly installed and must not be stored in a building, garage or any
other enclosed areas.
11. This appliance is certified by CSA (Canadian Standards Association) to ANSI Z21.97/CSA 2.41-2014,
Outdoor Decorative Gas Appliances.
IMPORTANT SAFETY INFORMATION ABOUT
PROPANE (LP) GAS
SPECIFICATIONS
Figure 1
Rated Heat Input (Liquid Propane & Natural Gas) 50,000 BTU/hr
Propane Regulator Pressure 11 inches water column
Natural Gas Inlet Pressure 7 inches water column
Clearance to combustible surfaces Sides: 24in. (610mm), Top: 72in. (1829mm)