Instruction Manual
Table Of Contents
骨传导无线耳机
耳机处于关机状态,长按开机键,保持3秒,LED蓝灯开机:
闪亮,提示音: power on;
耳机处于开机状态,长按开机键,保持5秒,LED红灯关机:
闪一下关机,提示音:poweroff;
关机状态,长按开机键3秒,进入配对状态,LED指链接BT:
示灯红蓝灯闪烁,耳机提示音:Pairing;设备(智能手机、平
板电脑等)搜索到BH718,点击连接;
耳机成功连接至设备时,LED蓝灯5秒闪一下,耳链接成功:
机提示音:Connected;
暂停/播放:蓝牙连接音乐播放状态下,单击多功能按键为暂
停,再单击多功能按键为播放;
来电状态下:单击多功能按键为接听,长按2秒多接听/挂断:
功能按键为拒接电话 通话状态下,单击多功能按键为挂断
单击音量增加键;音量增加:
单击音量减小键;音量减小:
音乐播放状态下,长按音量加2秒下一曲:
音乐播放状态下,长按音量减2秒上一曲:
蓝牙链接状态,双击多功能按键进入语音助手,再语音助手:
双击多功能按键退出语音助手
开机状态下(不管是否配对),长按多功能键进入内存模式:
6秒听到叮咚提示音进入T卡播放模式,蓝牙自动停止,耳机自
动播放T卡歌曲,按照歌曲顺序循环
在T卡模式下,长按多功能按键6秒退出T卡模退出内存模式:
式,退出后自动进去蓝牙配对模式,提示pairing(如有回连
记录则自动回连最后一台设备)
耳机在开机或者关机状态下,插上带数据内存电脑端模式:
传输的数据线,插到电脑端后显示U盘模式,可以直接把下载
好的歌曲复制到U盘内,歌曲格式为:MP3
关机状态下开机键和音量减键同时长按5秒清清除配对信息:
除配对信息,红蓝灯同时闪烁1秒
使用充电线时,将耳机插入USB电源,充电状态下,充电:
LED指示灯为红色,充电完成时,则为蓝色;
6.5
15%
%
On: When the headphone is in power-off state, press
and hold power button for 3 seconds with blue LED
flickering, reminding tone: power on.
Off: When the headphone is in power-on state, press
and hold power button for 5 seconds with red LED
flickering once, reminding tone: power off.
Connect BT: When the headphone is in power-off state,
press and hold it for 3 seconds to enter a pairing state
with red and blue LEDs flickering and reminding tone:
pairing. After the device (smart phone, tablet computer,
etc.) discovers BH718, press it to connect.
Connected successfully: When the headphone is
successfully linked to the device, blue LED will flicker
every 5 seconds with reminding tone: Connected
Pause/Play: In the Bluetooth connection music playback
state, click the multi-function button to pause, and then
click the multi-function button to play;
Answer/Hang up: In the incoming call state: click the
multi-function touch button to answer, long press the
multi-function button for 2 seconds to reject the call. In
the call state, click the multi-function touch button to
hang up
Vol+: Press the Vol+ once to turn up the volume.
Vol-: Press the Vol- once to turn down the volume.
Next song: Long press "V+" for 2 seconds when music is
playing
Previous song: Long press "V-" for 2 seconds when
music is playing
Voice assistant: Keep Bluetooth link, and double-click
the multi-function button to turn on the voice assistant,
then double-click it again to exit.
Enter memory mode: Keep the device power-on (no
matter whether it is paired or not), long press the multi-
function button for 6 seconds till the tone rings. Thus the
device enters the memory play mode, the Bluetooth
automatically stops, and the headset will automatically
play and loop T card songs in order.
Exit memory mode: Long press the multi-function
button for 6 seconds to exit memory mode, and it will
automatically enter Bluetooth pairing mode, showing
"pairing" (in case of a connection record, it will
automatically reconnect to the last device)
Memory computer mode: Connect the headset, either
power-on or power-off, to the computer with a data
cable that can transmit data. When the computer
displays U disk mode, copy the downloaded song to the
U disk in a format of MP3
Clear pairing information: Press the power button and
the volume off button for 5 seconds to clear the pairing
information in shutdown mode, Red and Blue light blinks
1 second spontaneously
Charging: In case of using charging line for charging,
connect the headphone with the USB power. During the
charging, LED turns red. After charging, the LED turns
blue.
9
9