Super International Manual

Choose a layout from the Instruction Sheet.
Place cars on track. Make sure guide pin ts into slot.
Squeeze trigger to make cars go faster. Release trigger to stop the car.
Always disconnect the power pack when not in use. Never pull on wires,
only pull on the plug.
Assemble track pieces on a at, clean surface, preferably not on carpet.
Attach a guardrail to each curve section.
Snap the bridge supports together and attach to track as needed.
The 2-Way Racing Plug allows you to change direction of travel.
Slide the controller plugs and 2-Way Racing Plug into terminal track as shown.
Plug power pack into an electrical wall outlet.
Operate only 1 car per lane!
If power cord is damaged in any way, it must be repaired or replaced by
the manufacturer or a similar qualied person to avoid a hazard.
NOTE: Occasionally, preservative will cause the controller to emit a little
smoke when used the rst few times.
This is normal and goes away after several minutes.
GO TO AFXRACING.COM FOR ADDITIONAL TIPS AND VIDEO INSTRUCTION
GETTING STARTED
Always clean the track before you start racing. Use an eraser or coin to clean the track
rails, then a clean, dry cloth to wipe away residue.
Blow out any material that may have fallen into the slots.
NEVER use Steel Wool to clean the track.
IMPORTANT!!
NOT RECOMMENDED FOR CHILDREN UNDER 8 YEARS OF AGE
AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE
OBSERVED DURING HANDLING AND USE TO PREVENT ELECTRIC SHOCK
CAUTION-ELECTRIC TOY
PARENTS PLEASE NOTE: IT IS RECOMMENDED THAT THIS TOY BE
PERIODICALLY EXAMINED FOR ANY FAULTS AND SHOULD NOT BE
USED UNTIL REPAIRS ARE MADE.
POWER PACK RATING: INPUT: 120VAC, 60Hz, 450mA
OUTPUT: 22.0VDC, 1A, 22.0VA; 12.0VDC, 1A, 12.0VA; 8.0VDC, 1A, 8.0VA