Instructions / Assembly

TCS & TCV Series Fluorescent Sconce / Vanity
Models: 320216/7/8/9, 320224; TCS113, TCV213, TCV313, TCV413, TCV513
Page 1 of 1 8060376 Rev 2
Safety Precautions
Read all safety precautions and installation instructions
carefully before installing or servicing this fixture. Failure to
comply with these instructions could result in potentially fatal
electric shock and/or property damage.
It is recommended that a qualified electrician perform all
wiring. This fixture must be wired in accordance with all
national and local electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp
surface or in water.
Make sure that the power source conforms to the requirements
of the fixture. (See labels on fixture housing)
To reduce the risk of electrical shock, and to assure proper
operation, this fixture must be adequately grounded. To
accomplish proper grounding, there must be a separate ground
wire (green) or bare metal contact (metal conduit) between this
fixture and the ground connection of your main power supply
panel. The green ground screw location is clearly marked on
the gem bar.
This fixture is intended to be used for general indoor lighting in
dry or damp locations only
Assembly Instructions
1. Preparing for installation
A. Disconnect electrical power before installing or servicing any part of
this fixture.
B. Remove fixture; place the diffuser (2) and the bag with hardware off to
the side.
2. Wiring. All wiring must take place inside junction box.
Caution: Make sure power is off at fuse or circuit breaker box. Check power
wires for damage or scrapes. If power supply wires are within three inches of
ballast use wire suitable for at least 90°C (194°F). Note: Most dwellings built
before 1985 have supply wire rated to 60°C. Consult a qualified electrician
before installing.
A. This unit may not operate properly unless connected to a “grounded”
electrical circuit. Securely attach green (or green and yellow) wire to
green ground screw on back plate frame (1) with provided hardware.
B. Using wire connectors (provided), connect white supply wire to white
ballast lead. Connect black hot supply wire to black ballast lead. Do
not mix wires. Pull on each wire to make sure connections are secure.
Make certain no bare wires are exposed outside of wire connectors.
3. Fixture mounting.
A. Back pan mounting options
1. Gem Bar Mounting – Using short screws (8) use holes in gem bar (7) and fasten with hex-nuts (6) for final back pan
mounting. With the long screws (not shown), secure universal round gem bar to junction box (not supplied).
2. Secure to Wall – Align back pan frame (1) with screws (8) and fasten with supplied thumbnuts (5).
4. Diffuser Installation
A. Align diffuser in appropriate socket housing on back plate frame (1).
B. Secure diffuser (2) with socket nut (3).
5. Lamp Installation
A. Install appropriate 13W / GU24 base lamp (4) by rotating into socket (9).
6. Power to the fixture can now be restored.
Limited Factory Warranty
AFX hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 2
years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not cover failure due
to improper installation, misuse, mishandling or damage incurred in transit.