Instructions / Assembly

E26 Bulb Indoor Luminaires
Vanity - Wall Mount
120VAC / 60Hz
Page 1 of 1 8061514 R0
Model #: AMDV2210MBxx
AMDV3310MBxx
Limited Factory Warranty
AFX Inc. hereby warrants that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 5 years
from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not cover failure due to improper
installation, misuse, mishandling or damage incurred in transit. For questions, please class AFX 1-800-873-2326.
Safety Precautions
 Read all safety precautions and installation instructions carefully before installing or servicing this fixture. Failure to comply with these instructions could result in
potentially fatal electric shock and/or property damage.
 It is recommended that a qualified electrician perform all wiring. This fixture must be wired in accordance with all national and local electrical codes.
 Do not handle any energized fixture or attempt to energize any fixture with wet hands or while standing on a wet or damp surface or in water.
 This fixture is designed for use in a 120VAC / 60Hz circuit.
 Make sure that the power source conforms to the requirements of the fixture. (See labels on the fixture housing).
 To reduce the risk of electrical shock, and to assure proper operation, this fixture must be adequately grounded. To accomplish proper grounding, there must be a
separate ground wire (green) contact between this fixture and the ground connection of your main power supply panel.
 This fixture is intended to be used for general indoor lighting in dry or damp locations.
Assembly Instructions
Step 1 – Preparing for installation
A. Disconnect electrical power at fuse or circuit breaker box before
installing or servicing any part of this fixture.
B. Carefully remove the fixture from the carton, remove components from
hardware kit.
C. Install mounting bracket (1) to junction box (not included) using two
screws (2) to secure it.
Wiring – All wiring must take place inside junction box (not
included)
Caution: Make sure power is off at fuse or circuit breaker box. Check
power wires for damage or scrapes. Use wire suitable for at least 90°C
(194°F). Note: Most dwellings built before 1985 have supply wire rated
to 60°C. Consult a qualified electrician to ensure correct branch circuit
conductor before installing.
Step 2 – Wiring fixture
A. Make all wire connections to appropriate wire. Secure with wire nuts
(provided).
B. Connect the green wire from the fixture to the supply source ground
wire.
C. Connect the black wire from the fixture to the black (L) wire from supply
power source.
D. Connect the white wire from the fixture to the white (N) wire from
supply power source.
E. Do not mix wires. Pull on each wire lead to make sure connections
are secure. Make certain no bare wires are exposed outside of wire
connectors. Tuck all connections neatly into the junction box.
Step 3 – Mounting
A. Install the fixture (3) by placing it over the mounting bracket (1) and use
two screws (4) to secure it.
Step 4 – Shade
A. Install glass shade (6) over the medium base socket by aligning 3 side
holes with the collar and using decorative screw (4) and rubber washer
(5) to secure it. Repeat until all glasses are secured to the fixture.
Step 5 – Lamping
A. Install three medium base bulbs (E26, 60W max. – not included) into each socket and turn clockwise until
secured. Note: some models will require 4 bulbs.
Step 6 – Restore power at fuse or circuit breaker box
View shown for reference
only. Individual models may
vary.