Owner manual

SETUP AND OPERATING PROCEDURES
15
Ag-Bag International, Ltd.
MB7010 HyPac November 2003
Section 4
CHECK SYSTEM PRESSURE
Before you can check the system pressures you need to let the engine run for several minutes.
Check the system Air Pres-
sure.
The gauge used for checking the
System Air Pressure is located
on the Center Control Console
and is item #11. There are two
needles on this gauge, (1) a red
needle which indicates the sys-
tem pressure and should read
between 100 - 120 psi as the
correct operating pressure, and
(2) a white needle which is the
engine end air brake pressure
indicator.
Check System Hydraulic Pres-
sure.
Because the Ag-Bagger
®
has a
split hydraulic system, two
gauges are required in order to
check the system. The systems
are grouped as (1) Cab End
Pressure and (2) Engine End
Pressure. The recommend pres-
sure should be 3000 psi on both
gauges.
Anchor Pressure Gauge
(3) Indicates the pressure placed
on the anchor cables during the
bagging operation
SYSTEM AIR PRESSURE
1 2
SYSTEM HYDRAULIC PRESSURE
1
2
3